8 replies to this topic

[jariail]

Have had eight slides in my WHPro feature slideshow, but suddenly only three of the eight are displaying. The slide show cycles from 1 to 2 to 3 and then back to 1. Need to fix this soon, any suggestions?

[Jenny]

Check to make sure that all 8 slide's information is still in your admin panel. Also make sure you have it set to show all 8.

[jariail]

Not sure where the button or area is to "show all 8." can you point me to that?

[Jenny]

It wouldn't be a button but rather a number that you type in for the maximum number to show. Most likely it would be in the theme feature settings.

[jariail]

Sounds like a good idea to have something like that, but I can't find that area in either the theme or the feature settings. In the past, when I added a new slide, it just automatically popped up as the next one in the sequence. I'm going to try to delete slides tomorrow morning and then see if I can add them back, one by one. Thanks for the suggestion, however.

[Danny]

Has your issue been resolved ?

[jariail]

No, not resolved yet.

[jariail]

Found the problem. The HTML code for the image for slide 3 was missing a concluding ">" character, and that omission brought down all the other slide displays. Once it was restored, all 8 slides were visible once again. Credit to my wife for puzzling out the cause of the error, which occurred when I made a mistake pasting in the code for a new slide 3 image file.

[Jenny]

Glad you were able to figure it out!